I installed the latest EBF today - EBF 22452, which is the 64-bit installation for PD 16.5 Service Pack 03 (build 4313). I was going to roll it back to SP02 because of the following issues:
- when I edit a file-based model extension, it doesn't ask me if I want to save the changes
- when I generate a new model, most of the time it doesn't present me with any options, just goes ahead and does it (assuming the model check doesn't throw up any errors)
- I couldn't pre-select the comparison options when selecting models in Tool | Compare models
- When I close a model it doesn't ask me if I want to save changes
- same applies for projects and the workspace
I say that I was going to roll it back, but now it's starting to behave. I did try using System Restore to roll it back, but that failed, something to do with a missing Microsoft file, so I thought I'd try out PD again. Strangely, the more I close down and restart PD, the more it behaves, so that I'm now only suffering from one of the above problems - it doesn't ask me if I want to save the XEM file if I've edited it, it just saves the file.
Am I the only one seeing this weird behaviour?